Measurements - CONDTROL HYDRO PRO Bedienungsanleitung

WOOD AND CONCRETE
EN
MOISTURE METER
Zero calibration
Press Activate zero calibration
It is necessary to take the sensor away from
foreign objects by 20cm.
Zero calibration is valid for the selected sensor
only.
To calibrate other sensors, one should be selected
by short press button
Press Zero calibration
Zero calibration allows setting the initial humidity
sensor readings to zero. Zero calibration should
be carried out at 10-15 minute intervals in order to
compensate the errors
10
HYDRO PRO CONDTROL
User manual
WOOD AND CONCRETE
EN
MOISTURE METER

MEASUREMENTS

Single measurement
Press Switch on the device.
Perform zero calibration (check paragraph «Zero
Press
calibration»)
Press Select the material (wood; concrete)
Press and Select the group of measured material
Select the sensor (front; bottom 15 mm; bottom
Press
30mm)
To obtain reliable measurement results, it is
necessary to ensure proper contact of the
sensor with the surface (there should be no
gaps between the sensor and the surface) and
check the measurement result on the display.
Tested surface should be smooth and clean, as
homogeneous as possible, without deep dents
and protrusions. The sensor should be pressed
with a force of about 1kg.
The result of humidity measurement of the site
(sample) is:
* for wood - the average value of at least three
measurements
* for concrete - average value of no less than five
measurements
HYDRO PRO CONDTROL
User manual
11