Care And Maintenance; Utilization; Warranty - CONDTROL XP4 Bedienungsanleitung

LASER DISTANCE METER
EN

CARE AND MAINTENANCE

Attention! The instrument is a precision device and requires careful handling. The
following recommendations will extend the life of the product:
- Do not point the product at the sun.
- Protect the product from bumps, falls, excessive vibration; do not let liquids,
construction dust and foreign objects get inside the product.
- Do not expose the product to extreme temperatures.
- If liquids get inside the product first remove the batteries, then contact a service
center.
- Do not store or use the product under high humidity conditions for a long time.
- Clean the product with soft wet cloth.
- Keep device optics clean and protect it from mechanical damage.
- Сarry out control measurements occasionally, especially if the product is subject
to excessive mechanical or other impact, before and after taking important
measurements.

UTILIZATION

Expired tools, accessories and package should be passed for waste recycle. Please
send the product to the following address for proper recycle:
CONDTROL GmbH
Wasserburger Strasse 9
84427 Sankt Wolfgang
Germany
Do not throw the product in municipal waste!
According to European directive 2002/96/ЕC expired measuring tools and their
components must be collected separately and submitted to environmentally
friendly recycle of wastes.
24
XP4 CONDTROL
User manual

WARRANTY

All CONDTROL GmbH products go through post-production control and are
governed by the following warranty terms. The buyer's right to claim about defects
and general provisions of the current legislation do not expire.
1) CONDTROL GmbH agrees to eliminate all defects in the product, discovered
during the warranty period, that represent the defect in material or workmanship
in full volume and at its own expense.
2) The warranty period is 36 months and starts from the date of purchase by the
end consumer (see the original supporting document).
3) The warranty doesn't cover defects resulting from wear and tear or improper
use, malfunction of the product caused by failure to observe the instructions of
this user manual, untimely maintenance and service and insufficient care, the use
of non-original accessories and spare parts. Modifications in design of the product
relieves the seller from responsibility for warranty works. The warranty does not
cover cosmetic damage, that doesn't hinder normal operation of the product.
4) CONDTROL GmbH reserves the right to decide on replacement or repair of the
device.
5) Other claims not mentioned above, are not covered by the warranty.
6) After holding warranty works by CONDTROL GmbH warranty period is not
renewed or extended.
7) CONDTROL GmbH is not liable for loss of profit or inconvenience associated with
a defect of the device, the rental cost of alternative equipment for the period of
repair.
This warranty applies to German law except provision of the United Nations
Convention on contracts for the international sale of goods (CISG).
In warranty case please return the product to retail seller or send it with defect
description to the following address:
CONDTROL GmbH
Wasserburger Strasse 9
84427 Sankt Wolfgang
Germany
LASER DISTANCE METER
EN
XP4 CONDTROL
User manual
25