Care And Maintenance; Utilization - CONDTROL HYDRO PRO Bedienungsanleitung

WOOD AND CONCRETE
HYDRO PRO CONDTROL
EN
MOISTURE METER
User manual

CARE AND MAINTENANCE

Attention! This device is a precision instrument and requires careful handling.
Maintenance of the following recommendations will extend the life of the
device:
- Protect the device from bumps, falling and intense vibration; do not allow
moisture, dust and foreign objects get inside the device.
- If liquids get inside the device, first remove the batteries, then contact a service
center.
- As soon as operation is finished, remove the particles of material, dirt, tar, etc.
from the sensor.
- Do not store and use the device in increased humidity conditions.
- Do not store the product in rooms where temperature is below -10°С. After
storage in low temperature conditions and subsequent transfer to a warm room,
the device heats up, causing moisture condense inside the device and damage
microcircuits.
- Do not expose the device to direct sunlight and protect it from prolonged
exposure to sunlight and high temperature.
- Clean the device with a soft cloth slightly made damp with a mild soap solution.
Do not use cleaning solvents or abrasives.
Failure to observe the following rules may lead to electrolyte leakage from the
batteries and damage the device:
- Remove the batteries from the device if you don't use it for a long time.
- Do not use batteries of different types, with different charge level.
- Do not leave discharged batteries in the device.

UTILIZATION

Expired tools, accessories and package should be passed for waste recycle. Please
send the product to the following address for proper recycle:
CONDTROL GmbH
Wasserburger Strasse 9
84427 Sankt Wolfgang
Germany
Do not throw the product in municipal waste!
According to European directive 2002/96/ЕC expired measuring tools and their
components must be collected separately and submitted to environmentally
friendly recycle of wastes.
14 14