AsViva T19 Benutzerhandbuch Seite 47

MAINTENANCE AND CARE
How to adjust the running belt?
1) Adjusting the screw on the left side of the belt by Allen Key, turning 1/4 times clockwise to adjust the
rear roller to tight the belt .
2) Repeat step 1 to adjust the right screw. it must be confirmed that the left and the right screw
adjusting at the same distance so that the rear roller can be paralleled to the treadmill frame.
3) Repeat steps 1 and 2 until the running belt does not slip.
4) Note: The running belt can't be adjusted too tightly, which will break the running belt and increase
the pressure of the front and rear rollers, causing problems such as roller bearing damage and abnor-
mal noise. If you want to reduce the tension of the running belt, turn the wrench counterclockwise. Note
that the left and right sides are rotated at the same distance.
!
Do not use sandpaper or solvents to clean the treadmill. The controller part of
the treadmill should not be exposed directly to the sun or moisture to avoid
damage. Please check and tight all part accessories of the treadmill frequently.
Damaged parts must be replaced immediately.
47