Herunterladen Inhalt Inhalt Diese Seite drucken

Remedy Of Faults; Maintenance And Cleaning - Oase Varionaut 365/DMX/02 Gebrauchsanleitung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

- EN -

Remedy of faults

Malfunction
Unit is not operating
Insufficient fountain height
Wear parts
The impeller unit is a wearing part and does not fall under the warranty.
Repair
A damaged unit must be put out of operation. Contact the OASE service.

Maintenance and cleaning

Attention! Dangerous electrical voltage.
Possible consequences: Death or severe injury.
Protective measures:
• Electrical units and installations with a rated voltage of U > 12 V AC or U >30 V DC located in the water:
Isolate the units and installations (switch off and disconnect from the power supply) before reaching into
the water.
• Isolate the unit before starting any work.
• Secure the unit to prevent unintentional switching on.
Cleaning the unit
Note!
Recommendation on regular cleaning:
• Clean the pump at least twice a year.
• Never use aggressive cleaning agents or chemical solutions. These could attack the housing surface or impair the
function.
• Recommended cleaning agent for removing stubborn limescale deposits:
– Pump cleaning agent PumpClean from OASE.
– Vinegar- and chlorine-free household cleaning agent.
• After cleaning, thoroughly rinse all parts in clean water.
How to proceed:
F, G
• Undo and remove screws (17), remove and clean filter basket (7).
• Refit filter basket after cleaning.
Storage/Over-wintering
Remove the unit at temperatures below zero degrees centigrade. Thoroughly clean and check the unit for damage.
Store the unit immersed in water or filled with water in a frost-free place. Do not flood the power plug!
Disposal
Do not dispose of this unit with domestic waste! For disposal purposes, please use the return system provided.
Disable the unit beforehand by cutting off the cables.
16
Cause
– Unit is switched off
– No mains voltage
– No control signals
– Internal electronic fault
– Filter basket soiled
– Water level too low
Remedy
– Check switch-on status/on-state
– Check mains voltage/supply cable
– Check control unit/control cable
– Please read the information about unit and
show programming.
– Clean filter basket
– Adjust water level

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis