Troubleshooting Guide - Vitek VT-1609 Betriebsanweisung

ENGLISH

TROUBLESHOOTING GUIDE

Trouble
When switching on the unit for the first time
unpleasant odor appears.
The unit does not operate
Amount of juice is reduced
Strong vibration during the operation.
The operation of the unit is accompanied
by noise, unpleasant odor, it heats up
strongly, smoke appears etc.
Specifications:
Power supply: 220-240 V ~ 50 Hz
Power consumption: 400 W (Max 500 W)
Specifications subject to change without prior notice.
MINIMUM SERVICE LIFE - 5 YEARS
GUARANTEE
Details regarding guarantee conditions can be obtained from the dealer from whom the
appliance was purchased. The bill of sale or receipt must be produced when making any
claim under the terms of this guarantee.
This product conforms to the EMC-Requirements as laid down by the Council
Directive 89/336/EEC and to the Law Voltage Regulation (73/23 EEC)
1609.indd 6 1609.indd 6
Solution
It is normal, as some time for seating of carbon brush
in the electric motor is necessary.
1. Check whether the unit is assembled properly, make
sure that the clamps is are locked.
2. Check the presence of voltage in the socket, for
this purpose connect any electrical appliance to the
socket.
1.The shredding sieve is blocked
- switch off the juicer; take the plug out of the socket.
- when the electromotor stops, check the shredding
sieve.
- clean and wash the shredding sieve.
1. Sticking of pressed skin on the side of the shredding
sieve.
- switch off the juicer; take the plug out of the socket.
- when the electromotor stops, check the shredding
sieve.
- clean and wash the shredding sieve.
2. The shredding sieve is damaged.
- check the shredding sieve, if there are some dam-
ages or cracks, replace the shredding sieve.
Stop using the unit immediately, disconnect it and
apply to the authorized service center for testing and
repair.
6
08.06.2009 16:33:57 08.06.2009 16:33:57