Tilt Protection; Troubleshooting; Maintenance, Cleaning And Storage - Silvercrest SHO 2000 A1 Bedienungs- Und Sicherheitshinweise

Starting up / Troubleshooting / Maintenance, Cleaning and Storage
▪
Please note: If the overheating protection is
triggered for the second time, you should turn
OFF the device and contact the service hotline
(see chapter "Service") - regardless of if you
have found the cause of the problem or not.

Tilt Protection


This device is equipped with an anti-tilt protec-
tion 3 . It is located at the bottom of the unit. If
the device is inadvertently knocked over or sub-
jected to a strong tilt during operation, the unit
switches off automatically. The unit only works in
upright position.

Troubleshooting


Fault Possible
cause
The The power plug
device is not plugged
cannot in.
be turned
ON.
The power outlet
does not pro-
vide voltage.
The temperature
regulator 5
is at the MIN
position.
The The heating level
device switch 2 is not
does not ON.
heat.
The temperature
regulator 5
is at the MIN
position.
The heating
element is
defective.
12 GB/NI/IE
M aintenance, Cleaning

and Storage
▪
Always disconnect the power plug when the
device is not in use and before any cleaning
or in the event of operating faults!
▪
Clean the device only when it is turned OFF
and in a cooled condition.
▪
Ensure that no moisture penetrates into the
device in order to avoid irreparable damage.
▪
Clean the housing with a soft dry cloth only.
Do not use aggressive and/or abrasive
cleaning agents.
▪
Remove dust deposits from the protective
grille with a vacuum cleaner.
▪
Store the device in a dry room.
Elimination
Insert the
power plug
into the wall
socket.
Check the
fuses in your
house.
Set the
temperature
regulator 5
to the MAX
position.
Set the
heating level
switch 2 to
the desired
operating
mode.
Set the
temperature
regulator 5
to the MAX
position.
Report the
case to the
after-sales
service.