Cd Operation - auna Oldschool Bedienungsanleitung

EN
38

CD OPERATION

PLEASE READ THIS IMPORTANT INFORMATION:
CD mechanisms used in devices like this are designed to fully read all
commercial CDs. They will also read self-compiled CD-R/CD-RW discs but
it may take up to 10 seconds for playback to start. If playback does not start,
it is likely due to the quality of the CD-R/RW disc and/or the compatibility
of the CD compilation software. Manufacturer is not responsible for the
playback quality of CD-R/RW discs.
Do not attach a label or seal to either side of the CD-R/RW disc. It may
cause a malfunction.
1. Slide the FUNCTION switch to CD/USB position. The display will show "-
-" briefly. If no CD has been loaded in the CD compartment, LED display
will change to show "no".
2. Grip the "OPEN" mark on the CD Door and pull gently to open it.
3. Carefully load an audio CD with its label side OUTward in the CD
compartment then gently close the CD door.
4. The player will start reading TOC of the disc, total number of tracks on
the CD will appear on the LED DISPLAY after a few seconds.
5. Press the PLAY/PAUSE button to start playing.
6. Adjust the MASTER VOLUME knob to obtain the desired sound.
7. To temporarily stop playing, press the PLAY/PAUSE Button. The play/
pause indicator will be flashing. To resume playing, press the PLAY/
PAUSE Button again. The play/pause indicator will be solid on.
8. You can skip up or down to a specific track number by pressing the SKIP
BACKWARD button or SKIP FORWARD button. The LED Display will
indicate the correct track number selected.
9. To locate a particular section within a track, press and hold the / button
until the section is found.
10. To stop playing, press the STOP button.
11. Slide the Function switch to POWER OFF position to off the unit after
listening.
+10 button control Press the +10 button once to advance the music search by
increment of 10 tracks.