Use Of Headphones (Not Included); Led Light Show; Resetting The Unit - auna Oldschool Bedienungsanleitung

EN
44
4. Slowly adjust both the volume controls of your unit and the external
device until you reach a comfortable listening level.
5. Turn off both the external audio player and this unit after use. Unplug the
audio cable from AUX IN jack
Notes:
• If you connect the unit to the Line-Out Jack of your external device, you
only need to adjust the VOLUME CONTROL of your unit. If you connect
to the Headphone Jack of your external device, you may need to adjust
both the volume controls of your external device and the unit to obtain
the desirable listening level.
• Remember to turn off the unit when you have finished listening. Don't
forget to switch off the power of your external audio device as well.

USE OF HEADPHONES (NOT INCLUDED)

Inserting the plug of your stereo headphones (not included) into the
headphone jack located on the top panel will enable you to listen in private.
When using headphones, the speakers will be disconnected.
Read this Important Information before Using Your Headphones
1. Avoid extended play at very high volume as it may impair your hearing.
2. If you experience ringing in your ears, reduce the volume or shut off the
unit.
3. Keep the volume at a reasonable level even if your headset is an open-
air type designed to allow you to hear outside sounds. Please note that
excessively high volume may still block outside sounds.

LED LIGHT SHOW

• To turn off the LED light show, press the LIGHT SHOW button.
• To turn on the LED light show, press the LIGHT SHOW button once
again.
Note: If the brightness is glaring, turn on room lights or turn off LED light
show.

RESETTING THE UNIT

In case of malfunction due to electrostatic discharge, reset the unit by slide
the FUCTION switch to POWER OFF position to reset the unit. Wait for 30
seconds before power on the unit again.