Cd Operation - auna Oakland DAB Bedienungsanleitung

CD OPERATION

1. Turn the volume knob clockwise to turn the equipment on.
2. Press the CD-Rom switch ,then the disk tray door opens .
3. Place the CD face up inside ,making sure it is fully placed .Then press the
CD-Rom switch again ,the disk tray door closes .
4. To play a different piece on the record, Press the skip up  or skip down
 button to select the desired piece .
5. To adjust the volume level, turn the volume knob to the right or left.
CD encoding
1. Set the function button to CD/USB/SD mode and then insert a memory
device (USB drive, SD or MMC card).
2. Press the record REC button, it will take 3 - 4 second to read the memory
device, then the USB or SD icon will be flashing on the LC display.
3. Press the skip up or skip down button to select the desired mode
(USB or SD) for encoding, then press the record REC button again to
confirm. (You can skip this step if only a USB drive or an SD/MMC card is
inserted.)
4. The system will start the encoding mode after a few seconds. Insert your
cassette into the playback slot. During encoding, the USB or SD icon will
be flashing on the display.
5. To finish encoding, press the stop button. The display will show "END"
and return to CD/USB/SD mode
Note: The recording speed is 1:1. Recording will take as long as playing the
record. The recording format is preset at MP3 bit rate 128 kbps.
EN
45