Precautions On Installing The Projector - Epson ELPMB60 Installationsanleitung

Using the Product Safely

Precautions on Installing the Projector

Installing the projector should only be performed by a professional with the necessary skills
and know-how.
If installation work is not carried out correctly, the mount or the projector could fall or topple over
causing injury or accident to occur.
Follow the instructions in this guide when performing installation work.
If the instructions are not followed, the mount or the projector could fall or topple over causing
injury or accident to occur.
Check that the structure and material of the installation location are strong enough before
installing, and use the optimum installation method.
If work is not carried out correctly, the mount or the projector could fall or topple over causing
injury or accident to occur.
Installing on the ceiling or wall should be performed by at least two people. Also, make
sure you have a secure, stable footing so that you do not drop the mount or the projector.
When installing in a high location such as a ceiling, wall, or on a shelf, make sure you attach
the safety wire supplied to the mount and the projector to prevent the projector from
falling.
Do not attach anything to this mount except for EPSON projector's that are compatible
with this product.
If you attach a projector that is not compatible with this product, the mount could fall, topple over,
or be damaged causing death or serious injury.
Check the catalog for projectors that are compatible with this product.
When installing, make sure you install a breaker (with a rated current of 10 A or less) in a
location within reach.
If any problems occur during installation, turn off the internal wiring immediately.
Note the following when handling the power cable. Otherwise, it could cause a fire or
electric shock.
•
Do not handle the plug with wet hands
•
Do not use a damaged or modified power cable
•
Do not apply excessive force to the power cable
•
Do not trap the cable between parts of the mount and so on during installation
Do not wind cables around the projector or the mount.
When wiring cables and so on, route the cables so that it avoids the screws and bolts.
If the cables come into contact with screws or bolts, it could cause a fire or electric shock to occur.
Make sure you tighten the screws or bolts completely when installing.
If they are not tightened completely, the mount or the projector could fall or topple over causing
injury or accident to occur.
Do not loosen or remove screws for no reason while installing or removing this product.
Warning
2