Attaching The Projector To The Installation Location; Determining The Installation Position; Mounting Hole Positions And Dimensions; When The Mounting Location Is Concrete - Epson ELPMB60 Installationsanleitung

Installation Procedure
Attaching the Projector to the Installation
Location

Determining the installation position

Check the position where you want to project the image, and determine the mounting position for the Ceiling
mount/Floor stand.
Make sure you take into consideration the structure (strength and so on) of the installation location on which
you will install the Ceiling mount/Floor stand.

Mounting hole positions and dimensions

Anchor bolt mounting hole (M10)
Wood screw mounting hole (nominal diameter 5.1)

When the mounting location is concrete

Use two anchor bolts to attach the mount to a concrete surface. Make sure you acquire commercially available
anchor bolts.
Warning
•
Check in advance that the concrete for the installation area can withstand the combined mass of this product
and the projector, as well as any side-to-side movements that may occur due to earthquakes and so on. If the
concrete is fragile or has deteriorated over time, be sure to reinforce it securely with rebar and so on.
•
Anchors must be installed in accordance with standards and methods specified by the manufacturers of the
material to ensure that they do not break, loosen, or become misaligned.
•
Be sure to tighten all screws securely when installing or after completing angle adjustments.
After tightening screws, tighten them further to make sure that there are definitely no loose screws.
•
Note that we cannot accept responsibility for any accidents that occur if this product falls due to insufficient
strength and so on in the installation area.
12