Precautions On Handling After Installing - Epson ELPMB60 Installationsanleitung

Using the Product Safely
Do not install the projector in a location outside the projector's operating temperature
range.
Such an environment may damage the projector.
Install it away from air outlets such as air conditioners.
If the air from an air conditioner and so on flows directly over the projector, the temperature rises
and the projector may not operate correctly.
Install it away from fluorescent lights.
Some kinds of fluorescent lights could interfere with the remote control of the projector.
Install it in a location where strong light such as fluorescent light and direct sunlight does
not shine on the remote receiver.
If strong rays of light shine on the remote receiver, remote control operations may not be performed
correctly.
Make sure you install the projector in a location free from excessive dust and humidity to
prevent the lens or internal components from becoming dirty.
Do not install the projector in a location subject to high levels of dust or humidity, or in a
location subject to smoke or steam.
Otherwise, it could cause a fire or electric shock to occur. The projector's case could also deteriorate
and be damaged causing the projector to fall from the mount.
Examples of environments that could cause the projector to fall due to case deterioration
•
Locations subject to excessive smoke or airborne oil particles, such as factories or kitchens
•
Locations containing volatile solvents or chemicals, such as factories or laboratories
•
Locations where the projector could be subjected to detergents or chemicals, such as factories or
kitchens
•
Locations in which aroma oils are often used, such as relaxation rooms
•
Near devices that produce excessive smoke, airborne oil particles, or foam at events

Precautions on Handling After Installing

Never loosen the screws or bolts after installation.
Make sure that you check for any loose screws or bolts on a regular basis, and if any are loose,
tighten them completely. If they are not tightened completely, the mount or the projector could
fall or topple over causing injury or accident to occur.
Do not apply excessive force to the mount or hang from the mount.
Never disassemble or remodel this product except as instructed in this guide.
Do not use a wet cloth or solvents such alcohol, benzine, or thinner, when cleaning the
product.
Water could get into the projector or the case could deteriorate and crack causing an electric shock
to occur.
Caution
Warning
4