Installation Of The Indoor Unit - Acson international C Serie Installationshandbuch

The indoor unit must be installed such that there is no short
circuit of the cool discharge. Respect the installation
clearance. Do not put the indoor unit where there is direct
sunlight on unit. The location is suitable for piping and
drainage and it must have a large distance between a door
and unit.
Ceiling Concealed Mounting
• Use the hanger supplied with the unit.
• Make sure that the ceiling is sufficiently strong to
withstand the weight.
See Detail A
Insulation material
(fi eld supply)
Air outlet side
Aluminium tape
(fi eld supply)
Tighten
Detail A

INSTALLATION OF THE INDOOR UNIT

Air inlet side
Aluminium tape
(fi eld supply)
Field supply
Washer for hanger
bracket (attached)
Center distance of axle (see drawing below)
* Can be smaller than 300mm if ceiling is removable.
5CCY
10/15C/CR
20C/CR
25C/CR
28CR
38CR
50CR
60CR
Provide clearance for servicing ease and optimal air fl ow as
shown in the diagram.
1-8
A
A
L
L
300mm
or more
300mm* or more
Ceiling
2300mm or more
A mm (inch) L mm (inch)
881 (34.7) 225 (8.9)
1041 (41.0) 225 (8.9)
1176 (46.3) 225 (8.9)
959 (37.8) 339 (13.3)
1264 (49.8) 401 (15.8)
1326 (52.2) 266 (10.5)
1526 (60.1) 266 (10.5)
Floor