Installation Diagram; Installation Of The Indoor Unit - Acson international C-Serie Montageanleitung

The indoor unit must be installed such that there is no short
circuit of the cool discharge. Respect the installation clearance.
Do not put the indoor unit where there is direct sunlight on unit.
The location is suitable for piping and drainage and it must have
a large distance between a door and unit.
Ceiling Concealed Mounting
• Use the hanger supplied with the unit.
• Make sure that the ceiling is sufficiently strong to withstand
the weight.
Insulation material
(field supply)
Air outlet side
Aluminium tape
(field supply)
Detail A
CC CC10CW
A (mm) 741
L (mm) 225
CC CC30CW
A (mm) 956
L (mm) 266

INSTALLATION DIAGRAM

CORK TAPE FULLY INSULATED
INSULATION THROUGH OUT CHILLED WATER PIPING

INSTALLATION OF THE INDOOR UNIT

See
Detail A
Air inlet side
Aluminium tape
(field supply)
Field supply
Washer for hanger bracket
(attached)
Tighten
CC15CW
881
225
CC38CW
1264
401
Do not install the unit at altitude over 2000m for both indoor and outdoor.
Center distance of axle (see drawing below)
Provide clearance for servicing ease and optimal air flow as
shown in the diagram.
* Can be smaller than 300mm if ceiling is removable.
CC20CW
1041
225
CC40CW
1076
266
! CAUTION
1-6
A
L
300mm
or more
300mm* or more
Ceiling
2300mm or more
CC25CW CC28CW
1176
225
CC50CW CC60CW
1326 1526
266
Floor
959
339
266