Hooking Up - Sony DPS-V55M Bedienungsanleitung

Hooking Up

• Before connecting this unit to another device, be sure to unplug the AC power cord from the power outlet.
• Turn off the power switch on this unit and all components to be connected, such as keyboards and active speakers
(speakers with built in amplifiers).
• After all the connections, double check that the connections are correct before plugging the AC power cord back into the
power outlet.
• If the connected components output large signals that cause distortion, adjust the INPUT LEVEL knobs on this unit to lower
the input level, or lower the output level of the connected component.
Example 1: Hooking up to instruments
Keyboard
IN
MIDI IN
DPS-V55M
Active
Speaker
Mixer (MDM-X4, etc..)
Example 3: Hooking up to a mixer (cutting the direct sound) (Stereo send, Stereo Return)
DAT Recorders
CD Players
etc
When using the processor in a send-return loop
• When using effect that have an effect level parameter, we recommend setting the direct sound to "0" so that only the sound of the
effect will be output.
• We also recommend setting the BYPASS function to "Muting" (as shown on page 18).
Electric Guitar
Guitar Pre-Amplifier
IN
OUT
Active
Speaker
Microphones
etc
Audio Mixing Console
Example 2: Hooking up a mixer (Mono send, Stereo return)
DPS-V55M
IN
Effect Send
(Monox2)
Active
Speaker
IN
Effect Send
(Stereo x 2)
DPS-V55M
Effect Return
(Stereo x 2)
OUT
OUT
Effect Return
(Stereo x 2)
Active
Speaker
Mixer (MDM-X4, etc..)
Main Monitor Speaker System
Power Amplifier
9
GB