Alarm Display During Camera Live Picture Viewing - Sony YS-SX310P Bedienungsanleitung

Alarm Display During Camera
Live Picture Viewing
When inputs such as a door bell, an interphone, etc.,
are connected to the CONTROL terminal, they will
send alarm triggers automatically. On the monitor
screen, "A" will flash instead of the camera number,
and the camera indicator, and depending on the alarm
setup (zoom or still), the corresponding button
indicator will flash.
While the camera indicator is flashing, press the
INPUT SELECT button for full screen display of the
camera live picture corresponding to the alarm trigger.
When an alarm trigger is received, the following will
take place.
If in sequence display or full screen display, the
display mode will automatically switch to 10-division
split screen display.
Even if the power to this unit is turned off: if the
monitor is turned on, the power to this unit will be
turned on automatically and the display will switch to
10-division split screen display. After the alarm
operation, the unit will be turned off automatically if
no button has been pressed (like pressing the INPUT
SELECT button to switch from split screen to full
screen display) during the alarm operation.
Note
The alarm operation cannot be canceled. Wait until the
alarm operation is finished.
Setup Example
The buzzer will ring for about 30 seconds, and the
image of the corresponding camera will zoom in and
freeze.
• The ZOOM, STILL and corresponding camera
indicators will flash. After 30 seconds, everything
will return to the mode previous to the alarm trigger.
Note
When the items MONITOR ZOOM or STILL have
been set to "ON", the display mode will not switch to
full screen display.
For the operation when the RETRIGGER line is set to
"ON", see "Alarm Settings" on page 14(EN).
29
(EN)