Sony YS-SX310P Bedienungsanleitung Seite 18

VCR SET Menu
ALARM REC SPEED
Set the duration according to the VCR alarm recording
duration.
SP: 3H, 12H, 24H, NC, F3H
LP: 6H, 18H, NC, F6H
NC: During alarm recording on the time lapse
VCR/time lapse VCR (LP mode), the
recording speed will remain the same.
When using the SW signal
If the SW OUT connector (time lapse) and the SW IN
connector are connected, the time lapse VCR SW
signal has higher priority.
Some time lapse VCRs/time lapse VCRs (LP mode)
do not output a SW signal in 3H mode (6H mode in LP
mode); to keep the same recording speed as the
connected VCR, set this unit as follows.
• Set "REC SPEED" to 3H or 6H (according to SP
mode or LP mode).
• When using an alarm recording of 3H (or 6H in LP
mode), set "ALARM REC SPEED" to "F3H" (or
"F6H" in LP mode).
• If using a time lapse VCR/time lapse VCR (LP mode)
with a switching output (SW OUT) function, then set
"FIELD" to "01", "TIMING" to "FIELD", "3H" to
"Y" (Yes).
TRIG.EDGE
HIGH EDGE: Will switch when the signal at the
SW IN terminal goes to High.
LOW EDGE: Will switch when the signal at the SW
IN terminal goes to Low.
18
(EN)