Abicor Binzel PP series Betriebsanleitung Seite 33

PP
WARNING
Risk of burns
The welding torches reach very high temperatures during welding.
• Allow the welding torches to cool down.
• Wear the correct protective gloves.
NOTICE
• The specified maintenance intervals are guidance values and refer to single-shift
operation.
• Maintenance and cleaning work may only be carried out by qualified personnel (in
Germany see TRBS 1203).
• Check the coolant hoses, seals and connectors for damage or leaks and replace if
necessary.
• Always wear your personal protective equipment when performing maintenance and
cleaning work.
• Remove any adhering weld spatter.
• Ensure that all threaded fittings are tight.
8.1 Replacing the wire feed roll
 Fig. 6 Feeding in the wire on page EN-12
NOTICE
• Required tools, crosstip screwdriver.
• Make sure that the wire feed roll complies with the diameter of the inserted wire
electrode.
1 Lift off clamping cap (2) and swing out seat clamp (7).
2 Lift off the flat-head screw (3) using the crosstip screwdriver and lift it off together with the
fixing plate (4).
3 Pull wire feed roll off the seat and replace it.
NOTICE
• Ensure tight fit of the wire feed roll in the seat.
4 Swing in seat clamp (7) and attach clamping cap (2).
BAL.0212.0 • 2018-07-16
8 Maintenance and cleaning
EN - 15