Environmental Protection/Disposal - Protool DRP 32-4 Handbuch

The switching diagram of both the change-over
switches of the gear speeds:
Attendance and Maintenance
This electric machine has been designed
so as to require a minimum attendance and
maintenance.
However, the following instructions
must be respected always:
‰ Keep the machine always clean
‰ No foreign objects are allowed to get into the
machine.
‰ After 300 hours of operation approximately,
a specialist should check up the carbon
brushes. In case these are shorter than
5 mm, they must be replaced with new
original brushes, and these must be "run-in"
during 20 minutes approximately of idle
run operation. At the same time, check the
condition of the commutator. An uneven
colouring of the individual segments and
grooves on the surface of the same indicates
that the machine must be sent to a repair
shop approved by the supplier.
‰ The gearing and driving mechanisms are
to be cleaned after 500 hours of operation
approximately. Since after the same time a
general overhaul of all the parts is necessary,
send the machine to a repair shop approved
by the supplier.
Storage
The unit should be stored in a dry place where it
is protected against freezing.
Service
See enclosed sheet.
10
Environmental Protection/
Disposal
Power tools, accessories and packaging should
be sorted for environmental-friendly recycling.
Only for EC countries:
Do not dispose of power tools into
household waste!
According to the European Directive 2002/96/
EC on waste electrical and electronic equipment
and its incorporation into national law, power
tools that are no longer suitable for use must be
separately collected and sent for recovery in an
environmental-friendly manner.
REACh
REACh is a European Chemical Directive
that came into effect in 2007. As "downstream
users" and product manufacturers, we are
aware of our duty to provide our customers
with information. We have set up the following
website to keep you updated with all the latest
news and provide you with information on all
the materials used in our existing products:
http://www.tts-protool.com/reach
Guarantee
Our equipment is under warranty for at least
12 months with regard to material or production
faults in accordance with national legislation.
In the EU countries, the warranty period for
exclusively private use is 24 months (an invoice
or delivery note is required as proof of purchase).
Damage resulting from, in particular, normal
wear and tear, overloading, improper handling,
or caused by the user or other damage caused
by not following the operating instructions, or any
fault acknowledged at the time of purchase, is
not covered by the warranty.
Complaints will only be acknowledged if the
equipment has not been dismantled before being
sent back to the suppliers or to an authorised
PROTOOL customer support workshop. Store
the operating instructions, safety notes, spare
parts list and proof of purchase in a safe place.
In addition, the manufacturer's current warranty
conditions apply.
Note
We reserve the right to make changes to the
technical data contained in this information as
a result of ongoing research and development
work.