Jacobsen HR 5111 Betriebs- Und Sicherheitshandbuch Seite 11

Left Engine
Turn Oil
Signal Light Temperature
Alert
1. Engine Oil Pressure - Alarm sounds
and oil pressure light comes on. Oil
pressure low.
2. Engine Coolant
Horn sounds. Engine
temperature high.
3. Charge Pressure Light stays on
after starting engine or comes on
during operation. Indicates
charge pressure in traction system.
4. Hydraulic Return Oil Filter - Oil
filter warning light comes on.
5. Hydraulic Oil Temperature Horn
sounds. Hydraulic oil temperature
high.
6. Hydraulic Charge Oil Filter - Oil
filter warning light comes on.
7. Air Filter - Air filter warning light
comes on.
Engine Charge
Coolant Pressure
Light
Light
Stop tractor immediately, lower implements and shut off engine! Inspect oil
level in engine. If oil light remains on with oil at proper level, shut off engine and
tow or trailer tractor back to service area. NEVER operate engine with oil light on,
severe damage to the engine can occur.
Temperature Stop tractor immediately, lower implements and shut off engine! Remove
coolant
debris such as leaves and grass clippings that may be restricting air flow through
rear screen on hood and area between radiator and oil cooler. If engine continues
to run hot, return tractor to service area.
CAUTION: Engine coolant is under pressure. Turn engine off and allow
!
fluid to cool before checking fluid level or adding coolant to radiator.
Stop tractor immediately, lower implements and shut off engine! Check
hydraulic oil level in main tank. Visually inspect tractor for obvious signs of leaks
low
around connections, hoses and tubes. Tow or trailer tractor back to service area.
Never operate tractor with charge pressure light on, severe damage to hydraulic
system components can result.
CAUTION: Hydraulic system is under pressure. Turn engine off and allow
!
oil to cool before checking oil level or adding oil to tank.
Return tractor to a service area as soon as possible. Change hydraulic return
oil filter.
Stop tractor, disengage drives and lower implements. Run engine at low idle
for a few minutes until light goes off. If light remains on, shut off engine and allow
hydraulic system to cool. Remove debris such as leaves and grass clippings that
may be restricting air flow through rear screen on hood and area between
radiator and oil cooler. If engine continues to run hot, return tractor to service
area.
CAUTION: Hydraulic system is under pressure. Turn engine off and allow
!
oil to cool before checking oil level or adding oil to tank.
Return tractor to a service area as soon as possible. Change hydraulic
charge oil filter.
Return tractor to a service area as soon as possible. Change air filter.
Return Hydraulic
Filter Oil
Light Temperature
Light
CONTROLS
Charge Air
Filter Filter
Light Light
Action
4
Glow Right
Plug Turn
Light Signal
Figure 4A
GB-11