Renfert SILENT TC Kurzanleitung Seite 15

Introduction
This Quick Start Guide contains instructions on the operation of the product
and relevant safety information.
For detailed information about the device, see the instructions for use which
you can download from our website at www.renfert.com/p915.
Enter the following item number: 29350000.
Symbols used
In the instructions for use and on the unit itself you will find these symbols with the following meanings:
Danger
Immediate risk of injury. Consult accompanying documents!
Electrical current
This indicates a risk of injury due to electrical current.
Caution
Risk of damage to the unit if the instruction is not followed.
Notice
A general notice that improves and eases use.
The appliance complies with applicable EU directives.
Within the EU, this device is subject to the provisions of the directive 2002/96/EC (WEEE direc-
tive).
Other symbols are explained as they occur.
Safety
Intended Use
This device is designed to extract dry, non-explosive dust.
The unit is intended solely for use in a commercial dental laboratory and dental practice.
The intended use also includes compliance with the instructions specified by the manufacturer concerning
operation, servicing and maintenance.
Improper Use
The equipment is not suitable for use with dental CAM units!
For information concerning SILENT extraction units for CAM machines, please refer to
www.renfert.com.
Fire-promoting, easily flammable, red-hot, burning or explosive materials must not be suctioned into the
device. It is not permitted to suction liquids. This device is not intended for private, household use.
Any use other than specified in these instructions is deemed improper and constitutes a misuse of the
device. The manufacturer shall not be liable for damages caused by improper use.
Only spare parts and accessories supplied or authorized by Renfert GmbH may be used with this prod-
uct. If other spare parts or accessories are used, this could have a detrimental effect on the safety of the
device, increase the risk of serious injury and lead to damage to the environment or the device itself.
Hazard and Warning Information
General Information
► If the device is not operated according to the enclosed documents, the provided protection is no
longer guaranteed.
► The device may only be operated using a mains cable with the country-specific plug system. Any
necessary alterations must be carried out by a qualified electrician.
► The device may only be operated if the information on the identification plate conforms to the
specifications of your local mains power supply.
After removing the Dust Drawer, you can find the identification plate below, inside the device on
the left side.
► The device may only be plugged into outlets which are connected to the protective conductor
system.
► The mains plug must be easily accessible.
- 1 -
EN