Configuration" Function - VWR SAS ISO 100 Contact Bedienungsanleitung

Press START to run multi mode.
At the end of the run the SAS will display a flashing delay before the next cycle; number of completed cycles and
residual cycles (runs) are also displayed.

"CONFIGURATION" function

To start with one of the eight operator programmable configurations memorised.
If theoperator wants to use a pre-set configuration, (composed of site, identity, numbers of runs, numbers of cycles)
up to 8 additional configurations can be programmed into the unit.
Switch on the unit by touching the screen for at least two seconds.
Press MENU and select CONFIGURATION function by pressing the "UP" or "DOWN" arrows.
22
08/31/06 11.31
RUN 05 x 200 Lt.
START
08/31/06 11.31
[ 0023 ] ‐> 200 Lt.
START
08/31/06 11.31
DELAY RUNS 02/05
START
MENU
STOP
STOP