Using A "Set Delay" Programme To Delay Instrument Start - VWR SAS ISO 100 Contact Bedienungsanleitung

Change the digit indicated by pressing the "UP" or "DOWN" arrows and presses ENTER to go to the next figure.
Repeat until you reach the last digit and then confirm by pressing ENTER.
Note: The maximum air volume is 1999 litres.

Using a "SET DELAY" programme to delay instrument start

This function is used to set a delay time before the sampling cycle.
Switch the unit on by touching the screen for at least two seconds.
Press MENU and select SET DELAY function by pressing the "UP" or "DOWN" arrows.
Press ENTER to modify the delay time.
Select the desired delay time by pressing the "UP" or "DOWN" arrows.
The available delay times are 0 – 1 – 2 – 3 – 4 – 5 – 6 – 7 – 8 – 9 – 10 – 20 – 30 – 40 – 50 - 60 minutes.
Press ENTER to confirm.
When the delay is set (for example 5 minutes), you will see the delay time on the main display.
The message "DELAY" will then flash until the selected time is reached. The display flashes to confirm delayed
start has been selected.
14
MENU'
SET DELAY
CLEAR
SET DELAY
[ 00 ] Minutes
CLEAR
08/31/06 11.31
0250 Lt. DELAY 05 MIN
START
ENTER
ENTER
MENU