Connections - Sony HAR-LH500 Bedienungsanleitung

Connections

Connecting your personal computer with the HAR-LH500
Use a USB cable to connect your personal computer with the HAR-LH500.
HAR-LH500
To the USB connector
With the plug
correctly oriented,
insert it fully into the
connector.
Notes
• Be sure to install this software before connecting the HAR-LH500 to your computer.
If not, this software may not function properly.
• Be sure to log on through the administrator's account to install the software. (for
Windows 2000/Windows XP)
• Make sure each plug is straight when you insert it. Inserting it at an angle may damage
the connector parts.
• Connect the USB connector directly to the computer's USB port with a USB cable. If
you connect the two units via a USB hub, the computer may not be able to control the
connected HAR-LH500.
• In case of Windows 2000, turn off the PC before disconnecting the USB cable.
In case of Windows XP, click the "Remove Device" icon and stop the device before
disconnecting the USB cable.
• Some HAR-LH500 functions are not supported by M-crew for HAR-LH500.
• A single HAR-LH500 should be operated by a single computer loaded with the
"M-crew for HAR-LH500" software. If you use the same HAR-LH500 with more
than one computer in which the software has been installed, HAR-LH500 data may
not be properly read in. If this occurs, click the Reload button (refer to the Help).
USB cable
Computer
To the
computer's
USB port
<
Make sure to connect the
HAR-LH500 directly to your
computer. Do not connect
via a USB hub.
GB
11