Reset Function - Astralpool APH3 INVERBOOST Benutzer- Und Wartungshandbuch

7.6.3 Parameter settings or checking: P8/P9/P10/P11
7.6.3.1. Press first and then press
or to enter parameter checking.
7.6.3.2. Press again and press
setting then press
7.7. Reset function：
Long press" and
7.8.
7.8.1 It show current time or timer on/off if there is in parameter P4,P5,P6.
7.8.2 It show error code when there is troubleshooting in the heat pump.
Remark: it shows currenttime with below situation:
a、Compressor start within 10 minutes
b、Heat pump operation frequency change
c、During defrosting
d、Working mode is cooling mode
7.9.
7.9.1 Normally it show the temperature.
7.9.2 It show the parameter when there is parameter checking.
7.9.3 It show the parameter code when there is in P4,P5,P6.
7. Start-up
7. 7. Start-up Start-up
and
or
to save the setting and exit.
" in 10 second to reset the data.
of the Heat Pump
of of the the Heat Heat Pump Pump
on the same time in 15 second, the screen flash and press
to set parameter if needed, and press
- 35 -
to confirm the