Varian 929-0200 Bedienungshandbuch Seite 21

USE PROCEDURE
Controller Start-up
To start-up the controller, turn the main switch to ON,
after plugging the power cable into a suitable power
source.
Starting the Pump
The pump starts only when the controller is turned on
and the two interlocks (H.V. Cable and Remote
ON/OFF) are short-circuited. Please refer to section
"Technical Information" for further information.
Pump Shutdown
To shutdown the pump, turn the main switch placed on
the front panel to OFF.
MAINTENANCE
The MicroVac series controllers do not require any
maintenance interventions. Any intervention must be
performed by authorised personnel only.
When a fault has occurred it is possible to use the
Varian repair service or the "Varian advance exchange
service", that allows to obtain a regenerated controller
replacing the faulty one.
!
Before carrying out any work on the controller,
disconnect it from the supply.
WARNING!
If a pump is to be scrapped, it must be disposed of in
accordance with the specific national standards.
Meaning of the "WEEE" logo found in labels
The following symbol is applied in accordance with the
EC WEEE (Waste Electrical and Electronic Equipment)
Directive.
This symbol (valid only in countries of the European
Community) indicates that the product it applies to
must NOT be disposed of together with ordinary
domestic or industrial waste but must be sent to a
differentiated waste collection system.
The end user is therefore invited to contact the supplier
of the device, whether the Parent Company or a
retailer, to initiate the collection and disposal process
after checking the contractual terms and conditions of
sale.
16
INSTRUCTIONS FOR USE
DISPOSAL
87-900-089-01 (F)