Varian 929-0200 Bedienungshandbuch Seite 20

4
Pascal or Millibar Graduated Scale Installation
(Supplied as a Fitting)
The MicroVac series controllers are supplied with the
pressure scale expressed in Torr (Torricelli); however, it
is possible to replace it with another one, a Pa (Pascal)
or mBar (Milibar) graduated scale (supplied as a fitting).
To replace, proceed as follows.
After removing the desired label from the fitting
package, put label A on the existing one, matching the
holes C; then fix it using the push locks B.
2
1. Input module for the controller power supply. It includes
the protection fuse, the voltage changer, the power supply
3
plug, and the EMC filter (not included into the plug/voltage
switch assembly).
2. High voltage output connector for the pump (KINGS type)
power supply.
3. Connector for the output high voltage activation
(H.V. Cable Interlock).
4. Input/output signal connector for fittings
1
Controller Rear Panel
Pascal or Millibar Graduated Label Installation
15
INSTRUCTIONS FOR USE
87-900-089-01 (F)