Finishing Vacuuming If Vacuuming Started From Somewhere In The Room; Vacuuming Manually; Interrupting Vacuuming - Miele HS18 Gebrauchsanweisung

If the battery is low, the robot vacuum
cleaner will return to the base station
and recharge. II will appear in the dis-
play. The robot vacuum cleaner will
then carry on vacuuming.
Finishing vacuuming if vacuuming
started from somewhere in the room
The robot vacuum cleaner will return to
its starting point and switch to standby
after approx. 60 seconds.
The robot vacuum cleaner will stand
still when there is low battery capacity.
Charge the robot vacuum cleaner.

Vacuuming manually

You can use the direction buttons on
the remote control to vacuum a particu-
lar area of the room.
 While the robot vacuum cleaner is va-
cuuming, press and hold one of the
direction buttons.
The robot vacuum cleaner will turn in
the desired direction until you let go of
the direction button.
 Press and hold the + direction button.
The robot vacuum cleaner will travel in
the desired direction and continue to
vacuum.
 Press the  button on the remote
control or the  sensor in the control
field.
The original vacuuming process will
continue running.

Interrupting vacuuming

 Press the  button on the remote
control or the  sensor in the control
field.
The robot vacuum cleaner stops.
Press the button or the sensor again to
continue vacuuming.
If you lift the robot vacuum cleaner off
the floor during a pause and then place
it down somewhere else, rLOC will ap-
pear in the display when you activate it
again. The robot vacuum cleaner will
turn around and compare its new loca-
tion with its saved map data.
If the data is compatible, the robot va-
cuum cleaner will start cleaning and not
go over surfaces that have already been
cleaned.
If the data is not compatible, the robot
vacuum cleaner will not move.
rLOC in the display can only be can-
celled by pressing the button or the
sensor several times.
en
51