When To Replace The Battery In The Radio-Control Handle; How To Change The Battery In The Radio-Control Handle - Miele SGDF5 Gebrauchsanweisung

en
use. The level of soiling of the motor
protection filter and the exhaust filter
must be checked at this point.
The indicator must be reset each time
the filters are replaced. The vacuum
cleaner must be switched on to do this.
 Press the reset button.
The maintenance indicator will go out
and reset to zero.
The indicator can only be reset by
pressing the reset button after the light
has come on. Pressing the button at
any other time will have no effect.
When to replace the battery in the ra-
dio-control handle
Change the battery approximately every
18 months. One 3 V battery (CR 2032)
is required.
The vacuum cleaner can still be used
when the battery has run out or if
there is no battery fitted.
 Switch the vacuum cleaner on using
the On/Off footswitch  (Fig. 24).
The standby indicator  on the vacuum
cleaner will light up yellow.
 Press the restart button on the va-
cuum cleaner (Fig. 43).
The vacuum cleaner can continue to be
used, but only at maximum suction
power.
60
 WARNING! Keep batteries

out of reach of children.
Coin or button batteries containing
lithium can cause severe or fatal in-
juries within 2 hours of being swal-
lowed or placed inside any part of
the body. Non-lithium batteries can
also cause serious injuries if swal-
lowed or placed inside any part of
the body. Even flat batteries can still
be dangerous. If you suspect a child
has swallowed a battery or placed a
battery inside any part of their body,
seek medical advice immediately
(Australia: Poisons Information
Centre, Tel. 13 11 26; NZ: National
Poisons Centre, Tel. 0800 764 766).
Examine devices and make sure the
battery compartment is correctly se-
cured, e.g. that the screw or other
mechanical fastener is tightened. Do
not use if compartment is not secure.
Used batteries must be kept away
from children while awaiting disposal
and must be disposed of in a safe
manner.
How to change the battery in the ra-
dio-control handle (Fig. 44)
 Undo the screw on the battery com-
partment cover using a cross-tip
screwdriver and then remove the
cover.
 Replace the battery with a new one.
Make sure the polarity is correct.
 Replace the cover and tighten the
screw back up again.
 Dispose of the old battery in a muni-
cipal recycling facility.