Replacing One Type Of Exhaust Filter With Another; When To Change The Battery In The Radio-Operated Handle; How To Change The Battery In The Radio-Operated Handle; When To Change The Thread Lifters - Miele S 5211 Gebrauchsanweisung

en
Replacing one type of exhaust filter
with another (dia. 35)
Depending on model, your vacuum
cleaner will be fitted as standard with
one of the following exhaust filters:
a Air Clean
b Active Air Clean SF-AAC 50 (black)
c Active HEPA SF-AH 50 (blue)
Please note:
1. If you wish to replace the Air Clean
filter a with an Active Air Clean filter b or
an Active HEPA filter c, it is essential
that you remove the filter grille before
fitting the new type of filter.
2. If you wish to replace the Active Air
Clean filter b or the Active HEPA filter c
with an Air Clean filter a, then it is
essential that you also fit the filter grille *.
* Filter grille - see "Optional
accessories".
Do not use more than one exhaust
filter at a time.
The exhaust filter change indicator
light (with reset button - see dia. 36)
that is fitted on certain models is
designed to come on when the
Active Air Clean or Active HEPA
filter needs to be changed. The filter
change indicator light is irrelevant if
an Air Clean filter is being used, as
long as it is replaced every time a
new packet of Miele dustbags is
started. The indicator light will go out
when the reset button is pressed.
44
When to change the battery in the
radio-operated handle
Approx. every 18 months. One 3 V
battery (CR 2032) is required.
The vacuum cleaner can still be
used when the battery has run out or
if there is no battery fitted.
^ Switch the vacuum cleaner on using
the On/Off foot control s. The
vacuum cleaner is ready to use (in
stand-by mode).
^ Press the reset button for the exhaust
filter change indicator.
The vacuum cleaner can continue to be
used, but only at maximum power.
How to change the battery in the
radio-operated handle (dia. 41)
^ Open the cover to the battery
compartment using a screwdriver.
^ Replace with a new battery, making
sure the polarity is correct.
^ Replace the cover.
^ Dispose of the old battery
responsibly.

When to change the thread lifters

The thread lifters on the suction inlet of
the floorhead and upholstery nozzle
SPD 10 (depending on model) can be
replaced.
Check them from time to time to see if
the pile has worn down.