When To Replace The Battery In The Radio-Control Handle; How To Change The Battery In The Radio-Control Handle; When To Replace The Battery In The Led Handle - Miele SG-Serie Gebrauchsanweisung

en
use. The level of soiling of the motor
protection filter and the exhaust filter
must be checked at this point.
The indicator must be reset each time
the filters are replaced. The vacuum
cleaner must be switched on to do this.
 Press the reset button.
The maintenance indicator will go out
and reset to zero.
The indicator can only be reset by
pressing the reset button after the light
has come on. Pressing the button at
any other time will have no effect.
When to replace the battery in the ra-
dio-control handle
Change the battery approximately every
18 months. One 3 V battery (CR 2032)
is required.
The vacuum cleaner can still be used
when the battery has run out or if
there is no battery fitted.
 Switch the vacuum cleaner on using
the On/Off footswitch  (Fig. 24).
The standby indicator  on the vacuum
cleaner will light up yellow.
 Press the restart button on the va-
cuum cleaner (Fig. 43).
The vacuum cleaner can continue to be
used, but only at maximum suction
power.
62

 WARNING! Keep batteries
out of reach of children.
Coin or button batteries can cause
severe or fatal injuries within 2 hours
of being swallowed or placed inside
any part of the body. Even flat batter-
ies can still be dangerous. If you sus-
pect a child has swallowed a battery
or placed a battery inside any part of
their body, seek medical advice im-
mediately (Australia: Poisons Inform-
ation Centre, Tel. 13 11 26; NZ: Na-
tional Poisons Centre, Tel. 0800 764
766). Examine devices and make
sure the battery compartment is cor-
rectly secured, e.g. that the screw or
other mechanical fastener is
tightened. Do not use if compart-
ment is not secure. Used batteries
must be kept away from children
while awaiting disposal and must be
disposed of in a safe manner.
How to change the battery in the ra-
dio-control handle (Fig. 44)
 Undo the screw on the battery com-
partment cover using a cross-tip
screwdriver and then remove the
cover.
 Replace the battery with a new one.
Make sure the polarity is correct.
 Replace the cover and tighten the
screw back up again.
 Dispose of the old battery in a muni-
cipal recycling facility.
When to replace the battery in the
LED handle
Replace the batteries when necessary.
3 1.5 V batteries (AAA) are required.