Introduction; Certification; Warranty; Limitation Of Warranty - Pentair DIGITRACE NGC-20-C-E Installations-, Betriebs- Und Wartungsanleitung

1. InTRoDuCTIon

1.1 Certification

1.2 Warranty

1.3 limitation of warranty

1.4 Exclusive remedies

1.5 statement of compliance

4
Please read all instructional literature carefully and thoroughly before starting. Refer to
the inside front cover for the listing of Liabilities and Warranties.
NOTICE: The information contained in this document is subject to change without notice.
Please read these Operating Instructions before Commissioning the instrument. Keep the
operating instructions in a place which is accessible to all users at all times. Please assist
us to improve these operating instructions, where necessary. We are always grateful for
your suggestions.
Should any difficulties arise during start-up, you are asked not to carry out any
unauthorized manipulations on the instrument as this could affect your warranty rights!
Please contact the nearest Pentair Thermal Management subsidiary or the head office.
If any servicing is required, the instrument must be returned to the head office.
Pentair Thermal Management certifies that this product met its published specifications
at the time of shipment from the Factory.
This Pentair Thermal Management product is warranted against defects in material
and workmanship for a period of 12 months from the date of installation or 30 months
maximum from the date of shipment, whichever occurs first. During the warranty period,
Pentair Thermal Management will, at its option, either repair or replace products that
prove to be defective.
For warranty service or repair, this product must be returned to a service facility
designated by Pentair Thermal Management. The Buyer shall prepay shipping charges
to Pentair Thermal Management and Pentair Thermal Management shall pay shipping
charges to return the product to the Buyer. However, the Buyer shall pay all shipping
charges, duties, and taxes for products returned to Pentair Thermal Management from
another country.
Pentair Thermal Management warrants that the software and firmware designated
by Pentair Thermal Management for use with a product will execute its programming
instructions properly when installed on that product. Pentair Thermal Management
does not warrant that the operation of the hardware, or software, or firmware will be
uninterrupted or error-free.
The foregoing warranty shall not apply to defects resulting from improper or inadequate
maintenance by the Buyer, Buyer-supplied software or interfacing, unauthorized
modification or misuse, operation outside of the specifications for the product, or
improper installation.
NO OTHER WARRANTY IS EXPRESSED OR IMPLIED. PENTAIR THERMAL MANAGEMENT
DISCLAIMS THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A
PARTICULAR PURPOSE.
THE REMEDIES PROVIDED HEREIN ARE THE BUYER'S SOLE AND EXCLUSIVE REMEDIES.
PENTAIR THERMAL MANAGEMENT SHALL NOT BE LIABLE FOR ANY DIRECT, INDIRECT,
SPECIAL, INCIDENTAL, OR CONSEQUENTIAL DAMAGES, WHETHER BASED ON
CONTRACT, TORT, OR ANY OTHER LEGAL THEORY.
This equipment has been tested and found to comply with the low voltage directive
2006/95/EC and the electromagnetic compatibility directive 2004/108/EC. These limits
are defined to provide reasonable protection against harmful interference in a residential
installation (technical data mentions industrial application). This equipment generates
uses and can radiate radio frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
• Reorientate or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
ZIEGLER ENGINEERING
ü
www.ze-gmbh.de
š
info@ze-gmbh.de
NGC-20 INSTALLATION MANUAL