Overall View - Tecnotest easylight 432b Bedienungsanleitung

DESCRIPTION AND ASSEMBLY ___________________________ ELECTRONIC HEADLIGHT CENTERING DEVICE
1.0 - DESCRIPTION AND ASSEMBLY OF THE HEADLIGHT
CENTERING DEVICE
1.1 -

Overall view

Collimator.
1.
Column cover.
2.
8 × 40 hex screw.
3.
Column.
4.
Rubber plug.
5.
Rod
6.
Level.
7.
Optic chamber.
8.
Brake handle.
9.
1.2 - Headlight tester assembly
Strictly comply with the instructions on how to assemble the Headlight
Centering unit.
• Secure the tracks (15) to the floor by means of the suitable gains at the
distance separating the two wheels from the opposite one.
• Slacken the locking pedal (14), insert the column (4) into the dolly (12)
and fix it in place by means of the washer and nut (13).
• Remove screw (3) and insert the optic chamber (8) into the column (4)
after having slackened the two plugs (11) on the brake handle (9).
• Locate the bubble level (21) on the top side of the collimator unit (1).
• Insert the collimator unit (1) into the column (4).
• Insert the screw (3) into the relative hole in the collimator unit (1) and
tighten it strongly in place.
After assembly, effect an initial set-up which should be repeated after every
20/30 tests or whenever necessary.
• Position the appliance on the tracks (15).
36
Horizontal level adjuster knob.
10.
8 × 11 plastic plugs.
11.
Dolly.
12.
24 mm self-locking nut.
13.
Locking pedal.
14.
Tracks (4 pieces).
15.
RS 232 output for Serial link
16.
connector.
Auxiliary power supply.
17.
OPERATING INSTRUCTIONS
DESCRIPTION AND ASSEMBLY ___________________________ ELECTRONIC HEADLIGHT CENTERING DEVICE
1.0 - DESCRIPTION AND ASSEMBLY OF THE HEADLIGHT
CENTERING DEVICE
1.1 - Overall view
Collimator.
1.
Column cover.
2.
8 × 40 hex screw.
3.
Column.
4.
Rubber plug.
5.
Rod
6.
Level.
7.
Optic chamber.
8.
Brake handle.
9.
1.2 - Headlight tester assembly
Strictly comply with the instructions on how to assemble the Headlight
Centering unit.
• Secure the tracks (15) to the floor by means of the suitable gains at the
distance separating the two wheels from the opposite one.
• Slacken the locking pedal (14), insert the column (4) into the dolly (12)
and fix it in place by means of the washer and nut (13).
• Remove screw (3) and insert the optic chamber (8) into the column (4)
after having slackened the two plugs (11) on the brake handle (9).
• Locate the bubble level (21) on the top side of the collimator unit (1).
• Insert the collimator unit (1) into the column (4).
• Insert the screw (3) into the relative hole in the collimator unit (1) and
tighten it strongly in place.
After assembly, effect an initial set-up which should be repeated after every
20/30 tests or whenever necessary.
• Position the appliance on the tracks (15).
36
Horizontal level adjuster knob.
10.
8 × 11 plastic plugs.
11.
Dolly.
12.
24 mm self-locking nut.
13.
Locking pedal.
14.
Tracks (4 pieces).
15.
RS 232 output for Serial link
16.
connector.
Auxiliary power supply.
17.
OPERATING INSTRUCTIONS