Unpacking - DePuy Mitek FMS solo Bedienungsanleitung

Unpacking, assemby and initial
system check

Unpacking:

Verify that all items on packing list match the
products you have received (verify serial numbers
and references). Damage should be reported
immediately to FMS Customer Service
Department: Tel: +33 4 92 12 33 93 or
email: repair@fmsgroup.com
Save all packing material, as they will be required to
ship products in the event of a product return.
Assembly:
- Connect the power cord to the power
connection (14).
- Connect the foot pedal to the foot pedal
connection (16) on the back of the pump.
Note: numbers in ( ), refer to diagram in section 1.6.
Initial System Check:
- Turn the device ON by pressing the
POWER (4) pad.
- Switch the I/O switch (14) on �I�.
- Press the Pump Run/Stop pads (10) to Run.
- Press on all pads (an audible tone should be
heard for each pad pressed).

) on �I�.