Controller Setup - Panasonic CZ-64ESMC3 Installationshandbuch

Controller setup

1
Press and hold the 3 buttons for
4 seconds or more simultaneously.
, , ►
2
Select the item to set.
▲ ▼ →
3
Set.
▲ ▼ → →
*Factory default
Item
code
Main/Sub setting
 Set "Main" when using a single unit of the system controller.
 Set "Sub" when using in combination of a central control device such as intelligent controller.
01
 When using multiple system controllers in a case other than , set "Main"
only for one unit. In zone mode, set "Main" for one unit in each zone.
It is recommended to set "Main" for the system controller whose item code
03 "All/Zone mode" is set to "All mode".
System Controller address setting
02 Up to 10 system controller (CZ-64ESMC3) can be connected on the inter-unit control
wiring. When installing more than one unit, assign self addresses to avoid duplication.
All/Zone mode
All mode
Sets all the indoor units.
03 Zone 1, Zone 2, Zone 3 and Zone 4 mode
Sets only the indoor units in any of the Zone 1, Zone 2, Zone 3 and Zone 4.
Can control for each zone and each group.
See "Number-of-controlled-units mode" as well.
R/C prohibited setting
Sets Enable/Disable of the R/C prohibited setting function.
04
When the item code 05 "Central control/Remote control mode" is set to
"Remote control mode", this is disabled.
Central control/Remote control mode
Central control mode
• Disabling the setting function can be used.
05 Remote control mode
• Disabling the setting function cannot be used.
• The Prohibit R/C setting is disabled.
See "Number-of-controlled-units mode" as well.
Set contents Set data
0000: Sub
0001: Main*
• 0000: Address 1*
• 0001 to 0009: Address
2 to 10
• 0000: All mode*
• 0001: Zone 1 mode
• 0002: Zone 2 mode
• 0003: Zone 3 mode
• 0004: Zone 4 mode
• 0000: Disabling the
setting function set*
• 0001: Disabling the
setting function not set
• 0000: Central control
mode*
• 0001: Remote control
mode
(EN)
19