Mounting - Panasonic CZ-64ESMC3 Installationshandbuch

Mounting

When mounting the bottom case (step 2)
 Tighten the screws securely until they reach the bottom case.
(Otherwise, loose screw heads may hit the PCB and cause malfunction when
mounting the top case.)
 Do not over-tighten the screws.
(The bottom case may be deformed, resulting in fall of the unit.)
Embed the included switch box into the wall beforehand.
1
Preparation to attach the
controller
 Remove the control panel.
Control panel
 Remove the connector.
Pull out the connector while pushing the claw.
2
Mount to the switch box.
 Insert the controller to the switch
box (supplied) that has been
embedded in the wall.
 Mount the bottom case. (with the
power supply part attached) of the
controller to the switch box (with
small screws (supplied))
• Do not allow the connection to be
exposed to the external force of wiring.
3
Connector
Claw
Switch Box
(supplied)
Bottom case (with
the power supply
part attached)
Connect the connector, and attach
the control panel.
 Connect the connector.
Connector
Claw
Push in until the claw clicks.
 Attach it from above.
Cross-section view (Embedded state)
Wall
Switch Box
System
Controller
0 - 5 mm
Do not allow the
wires to come in
contact with parts
on the PCB.
(Caught wires may
destroy the PCB.)
 Push in until a
clicking sound
is heard.
119
mm
15
(EN)