Nuova Simonelli MicroBar Gebrauchsanweisungen Seite 69

DISPLAY
WASHING CYCLE
IS NEEDEDGIO
WASHING THE MILK
CIRCUIT IS NEEDED
SHUT DOWN CLEAN
66
CAUSE
The set number of cycles pro- The message will appear on
grammed before washing, the display but the machine
has been exceeded. will continue to deliver drinks.
The set number of hours pro- The message will appear on
grammed from time of last the display but the machine
milk based drink before will continue to deliver drinks.
washing, has been exceed-
ed.
An end of service wash was An end of service wash must
set for the delivery unit during be performed before the
the programming stage. machine is switched off.
EFFECT SOLUTION
Do a washing cycle (see para-
graph WASHING THE DELIV-
ERY UNIT
FOAMER)
Perform a washing cycle for
the milk foamer only. As in the
case of a complete washing
cycle, you must keep the key
pressed down
onds without, however, insert-
ing cleanser tablets for this
group's washing.
(See only points 1,2,3,4 of the
paragraph 'WASHING THE
DELIVERY UNIT AND MILK
FOAMER')
Press the ENTER key as
shown on the display. The
machine will automatically
perform an end of service
wash, dispensing approx.
50cm 3 (3.0512 cu in) of water
and will then switch off.
NOTE
AND MILK
for 5 sec-