Messages - Sony ODS-L10 Bedienungsanleitung

Messages

The alarm indicator on the front panel of the library flashes
red (error) or orange (warning) if there is a problem with
the library hardware or configuration settings. Selecting
ERROR STATUS from the menu will display the error
code (Error xx-xxx) or warning message.
Message Description
FAN1 Warning The speed of the fan has dropped.
The library continues to operate, however extended use will cause the temperature inside the library and
the drives to increase, risking failure or even fire.
FAN2 Warning
Consult your local Sony representative.
FAN1 Error The fan is not turning.
The library continues to operate, however extended use will cause the temperature inside the library and
the drives to increase, risking failure or even fire.
FAN2 Error
Consult your local Sony representative.
High TEMP! The temperature inside the library is too high.
The library continues to operate, however extended use will cause the temperature inside the library and
the drives to increase even further, risking failure or even fire.
Consult your local Sony representative.
Low TEMP! The temperature inside the library is too low.
The library continues to operate, however the HDD performance has deteriorated and may experience
difficulty reading and writing.
PowerUnit(A) Err An error was detected in the power supply unit.
Consult your local Sony representative.
PowerUnit(B) Err
DC Power Warning A DC voltage error occurred in the library.
The library continues to operate, however extended use will cause the temperature inside the library and
the drives to increase, risking failure or even fire.
Consult your local Sony representative.
ILL. SETUP! An error occurred when setting a value in the setup menu.
Reconfigure the setup item. If the same error persists, consult your local Sony representative.
JM Com Error Reboot the library. If the same error persists, consult your local Sony representative.
CC Com Error
SV Com Error
HDD1 Warning An HDD read/write error has occurred repeatedly. The HDD must be replaced.
Consult your local Sony representative.
HDD2 Warning
HDD1 Fail An HDD error occurred, and the drive cannot be accessed. The HDD must be replaced.
Consult your local Sony representative.
HDD2 Fail
Rebuilding xx% A data rebuild is in progress.
Do not turn off the power until after the rebuild finishes.
Update Err! The software update was not successful.
Reinstall the update. If the same error persists, consult your local Sony representative.
Turn off/on PWR! Restart the library to activate the changed settings.
DIPSW Error Could not read the DIP switch setting.
Reboot the library. If the same error persists, consult your local Sony representative.
RCX Pos Error Reboot the library. If the same error persists, consult your local Sony representative.
RCY Pos Error
RCZ Pos Error
PSU detect A redundant power supply unit is installed.
Check the settings in the Setup Menu screen.
34
Messages
Error codes are displayed predominantly for errors due to
hardware problems. If an error code is displayed, consult
your local Sony representative.
If a message appears, refer to the following error
description to resolve the issue. If the message display
persists, consult your local Sony representative.