Starting And Stopping; Starting; Stopping; Inserting And Removing Cartridges - Sony ODS-L10 Bedienungsanleitung

Starting and Stopping

Note
Always close the I/E tray when starting and stopping the
library. The library cannot be started or stopped while the
I/E tray is in the open position.

Starting

1
Check that the power supply cord is connected, then
turn on the main power switch on the rear panel of the
library.
2
Press the On/Standby switch on the front panel.
When the button is pressed, the On/Standby button
indicator is lit green.
Initialization ends and the library is ready for use when
the text on the library display stops flashing.

Stopping

1
Press the On/Standby switch for two seconds or
longer.
2
A shutdown confirmation message appears on the
display. Use the arrow buttons to select [Y], then press
the [ENTER] button.
3
Wait until the On/Standby button indicator changes
from flashing green to lit in red, then turn off the main
power switch on the rear panel.
Inserting and Removing
Cartridges

Opening the I/E Tray

Press the RELEASE button on the front panel to release
the I/E tray lock. When the RELEASE button is pressed,
the button indicator flashes and the unlocking process
starts. When the lock is released, the button indicator is lit
solid.
Note
Wait until the button indicator is lit solid, then open the
I/E tray.

Inserting and Removing a Cartridge

Insert a cartridge into a slot, and push the cartridge in all
the way until it stops.
1
2
3
4
5
Label attachment point facing up
When removing a cartridge, pull the cartridge out while
keeping it horizontal.
Closing the I/E tray
Slowly push the I/E tray all the way in to the library, and
check that the RELEASE button light goes Off.
Notes
• The I/E tray is not completely closed if the RELEASE
button light is On.
• Warning tone sounds if the I/E tray is left open for three
minutes or longer.
Starting and Stopping / Inserting and Removing Cartridges
29