Important Notes On Operation; Condensation; Precautions For Products With Built-In Hdd - Sony ODS-L10 Bedienungsanleitung

Important Notes on
Operation
Use and storage
Do not subject the unit to severe shocks
The internal mechanism may be damaged or the body
warped. Shocks may also damage the internal storage.
Do not cover the unit while operating
Doing so will cause temperatures to rise inside the unit,
possibly resulting in failure.
After use
Turn off the on/standby button.
If you plan not to use the unit for a long time, turn off the
main power switch on the rear panel as well.
Shipping
• To prevent damage to the internal storage, always power
the unit off.
• If sending the unit by truck, ship, air or other
transportation service, pack it in the shipping carton of
the unit.
• If the unit is shipped without being properly packed and
protected. Its Internal parts may be damaged.
Referring to the supplied Installation Manual, be sure to
mount the screws and fittings to ensure safe
transportation.
• If the unit is transported with the drive unit not removed,
the unit and the drive unit may be damaged during
transportation. Be sure to remove the drive unit from this
unit before proceeding to transportation.
Care of the unit
If the body of the unit is dirty, clean it with a soft, dry cloth.
In extreme cases, use a cloth steeped in a little neutral
detergent, then wipe dry. Do not use organic solvents such
as alcohol or thinners, as these may cause discoloration or
other damage to the finish of the unit.
In the event of operating problems
If you should experience problems with the unit, contact
your Sony service or sales representative.
Use and storage locations
Store in a level, ventilated place. Avoid using or storing the
unit in the following places.
• In excessive heat or cold (operating temperature range:
5 °C to 35 °C (41 °F to 95 °F))
Remember that in summer or in warm climates the
temperature inside a car with the windows closed can
easily exceed 50 °C (122 °F).
• In damp or dusty locations
• Locations where the unit may be exposed to rain
36

Important Notes on Operation

• Locations subject to violent vibration
• Near strong magnetic fields
• Close to radio or TV transmitters producing strong
electromagnetic fields.
• In direct sunlight or close to heaters for extended periods
To prevent electromagnetic interference from
portable communications devices
The use of portable telephones and other communications
devices near this unit can result in malfunctions.
It is recommended that the portable communications
devices near this unit be powered off.

Condensation

If you move the unit from a very cold place to a warm
place, or use it in a damp location, condensation may form
on the optical pickup.
Then, if the unit is operated in this state, recording and
playback may not be performed properly.
When you move or operate the unit in an environment
where condensation may form, be sure to insert a cartridge
in advance.
Precautions for products with built-
in HDD
This unit has built-in hard disk drives (HDD). A HDD is a
precision device. If subject to shock, vibration, static
electricity, high temperature or humidity, data corruption
can occur. When installing and using the unit, closely
observe the following precautions.
Protect from shocks and vibrations
When subject to shocks or vibrations, the HDD can be
damaged and corruption of data on the HDD can occur.
• When transporting the unit, use the specified packing
material. When transporting on a dolly or similar, use a
type which does not transmit excessive vibrations.
Excessive shocks and vibrations can damage the HDD.
• Never move the unit while it is powered.
• Protect all HDD-equipped devices in the rack from
shocks.
• Before removing or inserting the unit in a rack, make
sure that power to any other HDD-equipped devices in
the rack is also switched OFF.
• Place the unit on a level and stable location.
• Do not place the unit near other devices that may become
a source of vibrations.
Do not expose to static electricity
Remove any plastic items that can produce static
electricity (bubble wrap, etc.) from the work area. Also,