Cleaning And Maintenance - MPM MOD-33 Bedienungsanleitung

- Swing open the lid (10) by releasing the lock in the dust canister bottom and empty the
dust canister.
- Close the swing-open lid (10).
- Power on the vacuum cleaner to continue.
7. When done vacuum cleaning, stop the vacuum cleaner with the Power switch (5), empty the
dust canister, and recharge the battery.
8. The fully recharged battery lasts for up to 30 minutes of operation on the Low suction power
level. When the battery is low, the Power LED (6) starts flashing red, and the vacuum cleaner
stops running after a while. Recharge the battery to continue.
PARKING THE VACUUM CLEANER IN THE WALL MOUNT
The MOD-33 vacuum cleaner is delivered with a wall mount for stor-
age while not in use. To park the vacuum cleaner in the wall mount:
1. Choose a place on a wall high enough above the fl oor so that
the vacuum cleaner fi ts parked and with its telescopic wand and
electric brush (the electric brush must rest on the ground). Make
sure there is no wiring in the wall within the envelope of the wall
parking mount.
2. Attach the wall mount with the two screws included to a wall, a
piece of furniture, etc. The horizontal spacing of the screws shall
be 103 mm. Fasten the wall mount with both screws level in the
same plane. Do not drive the screws all the way into the substrate,
the screw heads shall be approx. 5 mm above it.
3. Attach the wall mount (30) to the screws.
4. Park the vacuum cleaner in the wall mount with the wand down-
ward (see Fig. 1).

CLEANING AND MAINTENANCE

CAUTION! Never immerse the vacuum cleaner, the battery charger, the bat-
tery or the battery dock in water!
CAUTION! Empty the dust canister and clean the filters after each use for the
best performance.
CAUTION! Maintain the vacuum cleaner powered off and disconnected from
the battery charger!
1. Clean the outer surfaces of the vacuum cleaner with a damp
cloth and wipe them dry. Use a bit of a neutral detergent to remove
persistent dirt.
2. Empty the dust canister and remove the pre-filter and HEPA filter (14).
Grasp the handle on the filter casing lid and rotate it counter-clockwise
(see Fig. 2) while holding the filter casing with the other hand. Now, you
will access and separate the pre-filter and the HEPA filter. Flush both
filters clean in warm water and leave them to dry completely. Once dry,
16
Fig. 1
Fig. 2
Fig. 3