Before First Use; Charging The Battery - MPM MOD-33 Bedienungsanleitung

BEFORE FIRST USE

1. Remove the vacuum cleaner from the cardboard box. Remove all stickers, shipping locks,
plastic bags, and filling material.
2. Inspect the vacuum cleaner carefully for damage which may have occurred in transport. If
damage is suspected, consult your reseller.
3. Assemble the vacuum cleaner (see Section "ASSEMBLING THE VACUUM CLEANER").
4. Charge the vacuum cleaner battery (see Section "CHARGING THE BATTERY").
5. Verify that your power mains match the nameplate ratings of the vacuum cleaner.
ASSEMBLING (AND DISASSEMBLING) THE VACUUM
CLEANER
1. Install the pre-filter and HEPA filter casing (14) in the
dust canister (11). Align the three bosses on the pre-fil-
ter and HEPA filter ring in the respective grooves in
the dust canister (11).
2. Mount the dust canister lid (15) on the dust canis-
ter (11) and gently rotate the former (15) clockwise to
lock it in position. The lid's three bosses will only fit
the grooves in one orientation. The dust canister lid
is removed by gently rotating it counter-clockwise.
3. Close the swing-open lid (10) inside the dust canis-
ter (11).
4. Connect the battery (27) to the battery receptacle (9).
The battery can now be removed by pressing its
release button on the rounded part of the battery
housing.
5. Install the dust canister with its lid in the motor mod-
ule (1). Secure the dust canister by the latch (7) in the
lower part of the motor module and press the dust
canister in position against the motor module. The
dust canister lock button releases the dust canister (16) from the motor module.
6. Connect either the wand (17) or a suitable tool to the wand port (13). The wand / tool can now
be removed by pressing the release button (18), (20) or (22), respectively.
7. The tools (23), (24) and (26) can be attached with the union piece (25).
CAUTION! Do not start the vacuum cleaner unassembled!

CHARGING THE BATTERY

 The Li-ion battery features a very high energy density for a long operation between recharging
and a low weight.
 Charge the battery before the first use. The full battery recharge time is approx. 4.5 to 5 hours.
 The battery can be recharged with the dock (29) or as installed in the vacuum cleaner.
14
Assembling the vacuum cleaner