Troubleshooting Storm; Error Codes - Pentair Fleck 5800 SXT Betriebsanleitung

15 - TROUBLESHOOTING STORM

Error Codes

NOTE: Error codes appear on the In Service display.
Error Code Error Type
---0 Motor Stall /Cam
Sense Error
---1 Motor Run-On
Error /Cycle
Sense Error
---2 Regen Failure
---4 Fail Safe Error
18 • MR12 Fleck 5800 Storm & Typhoon Downflow/Upflow
Cause
No state changes in the optical
sensor are detected for 6 seconds.
An undesired optical sensor state
change occured.
The system has not regenerated in
30 days.
Valve has failed to find position in
one minute.
Reset and Recovery
Unplug the unit an plug back in. Allow the control to attempt to find
position again.
Verify the optical sensor is in place with the wires connected to the
circuit board. Verify the motor and drive train components are in good
condition and assembled properly. Check the valve and verify that the
piston travels freely. Replace/reassemble the various components as
necessary.
Plug the unit back in and observe its behavior. If the error reoccurs,
unplug the unit, put it into bypass and contact technical support.
Non-critical error. Extra optical sensor pulse detected. Press any button
to clear the error. Press extra cycle button to advance motor to clear
error.
Perform a Manual Regeneration to reset the error code.
If the system is metered, verify that it is measuring flow by running
service water and watching for the flow indicator on the display. If the
unit does not measure flow, verify that the meter cable is connected
properly and that the meter is functioning properly.
Enter Master Programming Mode and verify that the unit is configured
as appropriate for the valve configuration. Check that the correct system
capacity and meter size has been selected.
Unplug the unit and plug it back in. If error continues, call technical
support.