User Programming Mode Typhoon - Pentair Fleck 5800 SXT Betriebsanleitung

13 - USER PROGRAMMING MODE
TYPHOON
Abbreviation Parameter
DO Day Override
RT Regeneration Time
H Feed Water
Hardness
RC or SF Reserve Capacity
CD Current Day
NOTE: Some items may not be shown depending on timer
configuration. The timer will discard any changes
and exit User Programming Mode if a button is not
pressed for 60 seconds.
User Programming Mode Steps
1. Press the Up and Down buttons for five seconds while in
service, and the time of day is NOT set to 12:01 PM.
2. Use this display to adjust the Day Override. This option
setting is identified by "DO" in the upper left hand corner of
the screen.
Figure 29
3. Press the Extra Cycle button. Use this display to adjust the
Regeneration Time. This option setting is identified by "RT"
in the upper left hand corner of the screen.
Figure 30
4. Press the Extra Cycle button. Use this display to adjust the
Feed Water Hardness. This option setting is identified by
"H" in the upper left hand corner of the screen.
Figure 31
Range: 1-199 hardness
5. Press the Extra Cycle button. Use this display to adjust the
16 • MR12 Fleck 5800 Storm & Typhoon Downflow/Upflow
Description
The timer's day override
setting.
The time of the day that
the system will regenerate
(meter delayed, timeclock,
and day-of-week systems)
The hardness of the inlet
water - used to calculate
system capacity for
metered systems.
The fixed reserve capacity.
The current day of week.
Fixed Reserve Capacity. This option setting is identified by
"RC" or "SF" in the upper left-hand corner of the screen.
Figure 32
6. Press the Extra Cycle button. Use this display to set the
Current Day of the Week. This option setting is identified by
"CD" in the upper left hand corner of the screen.
Figure 33
7. Press the Extra Cycle button to end User Programming
Mode.