Pentair Fleck 5800 SXT Betriebsanleitung Seite 16

12 - MASTER PROGRAMMING MODE
TYPHOON continued
15. Flow Meter Type (Display Code FM)
Press the Extra Cycle button. Use this display to set the type
of flow meter connected to the control. This option setting is
identified by "FM" in the upper left-hand corner of the screen.
Use the Up and Down buttons to select one of the 8 available
settings.
Abbreviation
P0.7
t0.7
P1.0
t1.0
P1.5
t1.5
P2.0
Gen
Figure 27
16. Meter Pulse Setting (Display Code K)
Press the Extra Cycle button. Use this display to specify the
meter pulse setting for a non-standard flow meter. This option
setting is identified by "K" in the upper left-hand corner of
the screen. Use the Up and Down buttons to enter the meter
constant in pulses per unit volume.
Figure 28
17. End of Master Programming Mode
Press the Extra Cycle button to save all settings and exit
Master Programming Mode.
Description
3/4" Paddle Wheel Meter
3/4" Turbine Meter
1" Paddle Wheel Meter
1" Turbine Meter
1.5" Paddle Wheel Meter
1.5" Turbine Meter
2" Paddle Wheel Meter
Generic or Other non-Fleck Meter
Fleck 5800 Storm & Typhoon Downflow/Upflow MR12 • 15