Master Programming Mode Storm - Pentair Fleck 5800 SXT Betriebsanleitung

9 - MASTER PROGRAMMING MODE
Time of
STORM
Day
Time of
Backwash
CAUTION Before entering Master Programming, please
Backwash
contact your local professional water dealer.
Length
MODE
Mode Up Arrow
Button
Press Mode button to cycle through programming options.
When timer is powered up, the display position will point to
Time of Day. Set time of day by holding the Up or Down arrow.
Hold the Extra Cycle button until the Program icon disappears
to save the current time.
5800 Meter Downflow/Upflow
Time Of Day
Time Of
Regen
12:00
NaCl
Salt
Amount
MODE
Figure 8
1. Press the Mode button to advance to Time of Regen. Push
the Up or Down arrow to adjust the time of regeneration.
2. Press the Mode button again to advance to Salt Amount.
Press the Up or Down arrow to adjust your salt dosage.
English timer range is 3-18 lbs. Metric timer range is 50-290
grams per liter.
3. Press the Mode button again to advance to Hardness.
Press the Up or Down arrow to adjust the setting to your
hardness. English timer range is 3 to 200 gpg. Metric timer
range is 30-200 mgl.
4. Press the Mode button again to advance to Capacity
Remaining. This is the amount of gallons the unit can treat.
This is not adjustable.
5. Press the Mode button again to advance to Resin. Use the
Up or Down arrow to adjust the amount of CuFt resin in
your tank. English timer range is 0.25-3.0 CuFt. Metric timer
range is 5-100 liters.
6. Hold the Extra Cycle button until the Program icon
disappears to save your programming.
7. If you are just changing one program step, hold the Extra
Cycle button until the Program icon disappears to save your
changes. If you do not hold the Extra Cycle button until the
Program icon disappears your changes will not be saved.
NOTE: This unit has a day of the week reserve. It
calculates a reserve for each day of the week based
on the past 4 weeks.
8 • MR12 Fleck 5800 Storm & Typhoon Downflow/Upflow
Filter
Capacity
PM
Capacity
Remaining
Resin
Down Arrow Extra Cycle
Button
Figure 7
Hardness
CaCO³
Capacity
Remaining
R
Figure 8
5800 Time Clock Downflow/Upflow
Time Of Day
Time Of
Regen
Salt
Amount
MODE
1. Press the Mode button to advance to Time of Regen. Push
the Up or Down arrow to adjust the time of regeneration.
2. Press the Mode button again to advance to Salt Amount.
Press the Up or Down arrow to adjust your salt dosage.
English timer range is 3-18 lbs. Metric timer range is 50-290
grams per liter.
3. Press the Mode button again to advance to Days Between
Regens. Range is 1 to 30 days.
4. Press the Mode button again to advance to Days to Regen.
This is not adjustable.
5. Press the Mode button again to advance to Resin. Use the
Resin
Up or Down arrow to adjust the amount of CuFt resin in
your tank. English timer range is 0.25-3.0 CuFt. Metric timer
range is 5-100 liters.
6. Hold the Extra Cycle button until the Program icon
disappears to save your programming.
7. If you are just changing one program step, hold the Extra
Cycle button until the Program icon disappears to save your
changes. If you do not hold the Extra Cycle button until the
Program icon disappears your changes will not be saved.
12:00
NaCl
Figure 9
Figure 9
Days Between
Regens
Days to
Regen
31
Resin