Placing Sprayed Material Into The Paint Cup; Bringing Into Use; Switching On; Switching Off - Parkside PFS 280 A1 Originalbetriebsanleitung

Before use / Bringing into use
Thoroughly stir the sprayed material again.
Before you start spraying, always carry out a
trial spray on the test surface (see "Spraying").
Placing sprayed material
Q
into the paint cup
Unscrew the paint cup
When spraying objects generally below the
gun, position the suction tube towards the front
of the gun, i.e. nearer the nozzle
head work, position the suction tube towards
the back of the gun, i.e. nearer the handle
Pour the sprayed material into the paint cup
and screw the paint cup
spray gun.

Bringing into use

Q
You can also sling the motor
der. Always hook the carabiners attached to the
carrying strap to the attachment eyes
14
If necessary, adjust the length of the carrying
strap to suit your requirements.
Ensure that the motor
the sprayed material during operation. Position
it at an adequate distance away, on a clean,
dust-free surface.

Switching on

Q
Insert the mains plug into the mains socket.
Press the ON / OFF switch

Switching off

Q
Press the ON / OFF switch
Pull the mains lead out of the mains socket.

Advice on use

Q
Spray as shown in Fig. D.
Do not switch the device on or off while it is
10 GB/IE
from the spray gun.
6
. For over-
8
5
6
tightly on to the
6
over your shoul-
11
.
14 a
cannot suck in any of
11
on the motor.
10
on the motor.
10
over the surface to be sprayed. Instead, start
and stop the spraying process approximately
10 cm outside the surface to be sprayed.
First spray the corners using short bursts of spray.
Then continue with spraying process in
accordance with Fig. D
– keep the spray gun parallel to the surface
– keep the spray gun upright laterally (don't
wobble from side to side)
– move the spray gun at a constant speed
– apply the sprayed medium as thinly as possible
– the layer(s) of sprayed medium need(s) to be
allowed to dry for some time before you ap-
. ply the next coat at right angles to the paths
of the previous coat (Fig. C). The coated sur-
face will have an even appearance if the
strips of sprayed material overlap by 4–5 cm.
Do not allow the paint cup
pletely while spraying – drops may form!

Selecting / replacing the nozzle

Q
Loosen the union nut
Insert the desired nozzle
Tighten the union nut

Adjusting the spray pattern

Q
Turn the spray control thumbwheel
desired position:
(–) = minimum spray rate
(+) = maximum spray rate
Note: We recommend that you start with the
minimum spray rate.
Wide jet nozzle
to empty com-
6
.
9
.
8
again.
9
into the
3
Jet