Placing Sprayed Material Into The Paint Cup; Bringing Into Use; Switching On; Switching Off - Parkside PFS 280 A1 Bedienungs- Und Sicherheitshinweise

Before use / Bringing into use
Proceed as follows for a sprayed material
that the manufacturer says must be thinned:
T ake a measuring cup
P our the required amount of sprayed material
into the paint cup
T hin the sprayed material by 10 % with the
thinner in accordance with the manufacturer's
instructions.
T horoughly stir the sprayed material again.
B efore you start spraying, always carry out a
trial spray on the test surface (see "Spraying").
Placing sprayed material
Q
into the paint cup
U nscrew the paint cup
W hen spraying objects generally below the
gun, position the suction tube towards the front
of the gun, i.e. nearer the nozzle
head work, position the suction tube towards
the back of the gun, i.e. nearer the handle
P our the sprayed material into the paint cup
and screw the paint cup
spray gun.

Bringing into use

Q
Y ou can also sling the motor
der. Always hook the carabiners attached to the
carrying strap to the attachment eyes
14
If necessary, adjust the length of the carrying
strap to suit your requirements.
E nsure that the motor
the sprayed material during operation. Position
it at an adequate distance away, on a clean,
dust-free surface.

Switching on

Q
I nsert the mains plug into the mains socket.
P ress the ON / OFF switch
10 GB
with millilitre graduations.
16
.
6
from the spray gun.
6
. For over-
8
tightly on to the
6
over your shoul-
11
14 a
cannot suck in any of
11
on the motor.
10

Switching off

Q
P ress the ON / OFF switch
P ull the mains lead out of the mains socket.

Advice on use

Q
S pray as shown in Fig. D.
D o not switch the device on or off while it is
over the surface to be sprayed. Instead, start
and stop the spraying process approximately
10 cm outside the surface to be sprayed.
F irst spray the corners using short bursts of spray.
T hen continue with spraying process in
accordance with Fig. D
– keep the spray gun parallel to the surface
– keep the spray gun upright laterally (don't
wobble from side to side)
– move the spray gun at a constant speed
– apply the sprayed medium as thinly as possible
. – the layer(s) of sprayed medium need(s) to be
5
allowed to dry for some time before you ap-
6
ply the next coat at right angles to the paths
of the previous coat (Fig. C). The coated sur-
face will have an even appearance if the
strips of sprayed material overlap by 4–5 cm.
D o not allow the paint cup
pletely while spraying – drops may form!

Selecting / replacing the nozzle

Q
.
L oosen the union nut
I nsert the desired nozzle
T ighten the union nut

Adjusting the spray pattern

Q
T urn the spray control thumbwheel
desired position:
(–) = minimum spray rate
(+) = maximum spray rate
Note: We recommend that you start with the
minimum spray rate.
on the motor.
10
to empty com-
6
.
9
.
8
again.
9
into the
3