Change Of Extruder; Recommendations For Use - FIMAR MPF15N Benutz Und Wartungsanleitung

▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬ PASTA FRESCA appliance
M) Indicator light: when on, the appliance is electrically powered.

CHANGE OF EXTRUDER

1. Loosen ring nut (N).
2. Replace extruder (P) with a piece suitable
for the kind of processing to be carried out
3. Screw ring (N).

RECOMMENDATIONS FOR USE

1. Assemble the appropriate tools for the process to be carried out (including dies ).
2. Lift the container guard.
3. Introduce the flour and then the liquid part respectively (do no introduce the liquid part
first because it will leak out of the die ).
4. Close the tank protection and trigger the protection micro switch by pushing it towards
the tank (only for model MPF15N - MPF25N).
5. Activate the food products kneading cycle.
– For model MPF15N - MPF25N: rotate selector (C) to "1" (kneading) and press the (A)
button to start the kneading cycle. To stop the appliance press the (B) button.
– For model MPF40N - MPF80N: position the (A) switch to "1" and press the (E) key
(kneading) to start the kneading cycle. To stop the appliance press the (B) button.
This cycle has an indicative duration of 6÷8 minutes.
6. If necessary, correct the mixture's consi-
stency by adding flour or liquid, in order to
obtain a granular mixture, suitable for ex-
trusion (see figure).
N
- 11 -
P
GB
English language